Description

A/F 6mm Brass Hexagon Bar

The A/F 6mm Brass Hexagon Bar is solid free-machining brass hexagon bar supplied cut to length.

It is available cut to your required length for fabrication, engineering and project use. Please review the grade, finish and suitability information below before ordering.

Technical Specifications

Key Features

• Hexagonal profile suited to machining
• Good machinability
• Available cut to your required length
• Suitable for fabrication using an appropriate process
• Useful for professional, trade and general engineering work

Benefits

• Good machinability with suitable tooling
• Attractive non-ferrous appearance
• Cut-to-length ordering can reduce material waste

Material Grade Information

This product is normally supplied in CW614N free-machining brass, traditionally known as CZ121, with material designation CuZn39Pb3.

The grade information shown is general supply information and does not guarantee that a particular grade, certificate or traceability will be supplied for an individual order.

If a particular material grade, certification or traceability is essential, please contact KI Metals before placing your order and obtain written confirmation from KI Metals.

Telephone conversations, verbal discussions, customer order notes, drawing notes and other instructions submitted with an order do not constitute written confirmation of material grade or certification requirements.

This machining brass grade normally contains lead as an alloying element. If lead content, regulatory compliance or suitability for a particular application is important, written confirmation must be obtained before ordering.

Surface Condition

Mill or drawn finish; brass naturally tarnishes with exposure.

Normal production, storage, handling and cutting variations are not automatically evidence of a product defect. If appearance is critical, contact KI Metals before ordering.

Typical Applications

• Machined Nuts And Fasteners
• Fittings
• Turned Components
• General Engineering

Design and Suitability

Product selection must not be based on dimensions alone. The required grade, loading, environment, connections, fabrication process and installation method should be specified or checked by a suitably qualified person where applicable.

KI Metals supplies material to the dimensions ordered but does not determine whether a particular item is suitable for the intended load, environment or application.

Cut to Your Required Length

Enter your required measurement in the Length box before adding the product to your basket. Material is cut to the ordered length with a standard cutting tolerance of ±3 mm.

Products are supplied as-cut and are not deburred. Contact KI Metals before ordering if a tighter tolerance, specific end preparation or additional processing is required.

Also Known As

• Brass Hexagon Bar
• Brass Hex Bar
• Brass Hexagonal Rod
• Free-Machining Brass Hexagon Bar

Fabrication and Safety

Use suitable tooling and control sharp swarf, chips and cut edges. The listed free-machining brass grades normally contain lead, so machining dust, fumes and residues must be controlled using appropriate extraction, hygiene procedures and personal protective equipment.

Confirm composition and regulatory suitability in writing before fabrication where lead content, drinking-water contact, food contact or another controlled application is relevant.

Frequently Asked Questions

Is a particular material grade guaranteed?

No. This product is normally supplied as CW614N (CZ121 / CuZn39Pb3), but a particular grade, material condition, certificate or traceability is only guaranteed where KI Metals confirms it in writing before the order is placed. Telephone conversations, verbal discussions, drawing notes and order notes are not confirmation.

Can I request a grade or certificate in the order notes?

You may provide information in the order notes, but an order note does not constitute confirmation. Contact KI Metals before ordering and obtain written confirmation.

Can this item be cut to my required length?

Yes. Enter the required measurement in the Length box before adding the product to your basket. The standard cutting tolerance is ±3 mm unless confirmed otherwise.

Is the material suitable for my project?

The customer is responsible for confirming material grade, dimensions, loading, environment, fabrication method and regulatory requirements. Structural or safety-critical selection should be checked by a suitably qualified person.

Safety Notice

Wear suitable gloves, eye protection and other appropriate personal protective equipment. Ensure the product is correctly supported and secured during storage, lifting, cutting, fabrication, transport and installation.